Pro-tools MB-105 Uživatelský manuál stáhnout pdf (Strana 12)

PAGE 12

QUALITY PRODUCTS BY PEOPLE WHO CARE (813) 986-9000

EXTENSION BAR USES

SOME SMALL DIES ARE TOO SMALL TO DRILL DRIVE HOLES.

IN THIS CASE THE OUTSIDE OF THE SWING ARM PUSHES

AGAINST THE U-STRAP DRIVE PIN.

HANDLE EXTENSION

U-STRAP

DRIVE PIN

WITH SMALLER TUBE SIZES, THE RATCHET IS NOT NEEDED. FOR A QUICK BEND, SIMPLY INSERT

THE HANDLE EXTENSION BETWEEN THE TWO BOLTS ON THE SWING ARM (AS SHOWN) AND PULL

THE HANDLE AND SWING ARM AROUND TO CREATE THE DESIRED BEND.

TUBE RELEASE PROCEDURE

PULL IN THIS DIRECTION

SOMETIMES AFTER COMPLETING THE BEND ON LARGE SIZE TUBING, THE DIE WILL NOT RELEASE THE

TUBE. IF THIS HAPPENS, REVERSE THE HANDLE EXTENSION (AS SHOWN), THEN GIVE A HARD YANK IN

THE OPPOSITE DIRECTION OF THE BEND.

1 2 ... 7 8 9 10 11 12 13 14

Žádné komentáře

Pro-tools MB-105 Uživatelský manuál Strana 12